Arlington Garage Door Pros
A garage door outfit built around Arlington's houses
Garage door repair for Arlington, TX and nearby areas like Grand Prairie and Kennedale, working on doors from the 1953-2014 housing stock common here.
Local detail
What Comes Next
Call the number below or fill out the form on the site and tell us what the door is doing - won't open, opens crooked, makes a bang when it moves, opener runs but the door doesn't budge. We ask for the make of the opener if you know it and roughly how old the door is, because Arlington's housing runs from 1953 up through 2014, with most of it going up in the 1980s and 90s, and that split changes what parts we bring. A door on a house built in the 90s usually has different spring sizing and track hardware than one from a 1950s build near the older parts of the city. We work Arlington itself along with the closer-in service area - Grand Prairie six miles out, Kennedale at seven, Forest Hill at nine, and Richland Hills at ten - plus the wider ring of towns further out. Once we know the door and the address, we can usually tell you the same day whether it's a same-visit fix or something that needs a part ordered in.
We don't do same-day for everything. Some torsion spring sizes and older-style track brackets on the pre-1980 stock aren't sitting on the truck, and we'll say so up front rather than guess.
The area
What We Do Not Take On
We don't touch gate operators, commercial rolling steel doors, or fire-rated doors - those are a different trade with different code requirements, and we'd rather send you elsewhere than pretend to know that work. We also don't do cosmetic-only jobs like repainting a door that's structurally fine; that's a paint contractor's job, not ours.
On the repair side, we're honest about when a door isn't worth saving. A steel door from the older end of Arlington's 1953-2014 build range that's been through enough hail and sun cycles to warp the panels usually isn't a good repair candidate even if the opener still runs - replacing it costs less over time than chasing bent track and cracked panels section by section. We'll tell you that plainly instead of billing for a patch that won't hold.
We also don't stock every spring size on the truck. Some of the older torsion setups on houses built before the 1980s wave of construction use hardware that's harder to source, and if that's what's on your door, the first visit may be a diagnosis and measurement rather than a fix, with the part ordered after.
What we find
What We Actually Do
Torsion and extension spring replacement, broken cable, off-track doors, worn rollers, opener repair and swap-outs, panel replacement on dented or storm-damaged sections, and track realignment - the standard list of what actually breaks on a residential door. Given that median household income across the service area sits at $84,552 with 97,142 owner-occupied houses among the roughly 189,893 households, most of the calls we get are homeowners maintaining a house they plan to stay in, not landlords doing the minimum. That shapes the work toward doing the repair right rather than the cheapest patch.
The housing stock across the 22 named areas we cover skews 1980s-90s, which is the range where we see the most consistent spring and opener setups - parts we carry regularly. Arlington's summer heat load is moderate rather than extreme by national standards, so we don't see the same rate of foam-and-panel breakdown you'd get in a harsher climate zone, but daily thermal cycling still loosens track bolts and dries out roller bearings over years of use, and that's a steady share of our calls regardless of the house's age.
Questions
Common questions
Do you work outside Arlington itself?
Yes. Along with Arlington we cover the surrounding service area, including Grand Prairie, Kennedale, Forest Hill, Richland Hills, and towns further out like Keller and Midlothian. Call with your address and we'll confirm the same day whether it's within range.
How do I know if my door needs a repair or a full replacement?
If the frame, track, and opener are sound and it's one broken part - a spring, cable, or roller - repair is usually the right call. If the panels are warped or cracked in multiple spots, especially on an older door, replacement often costs less over the long run than repeated patchwork.
Do you carry parts for older doors on the truck?
For the common 1980s-90s hardware, generally yes. For some older torsion setups on pre-1980 houses, the spring size isn't something we stock routinely, and the first visit may involve measuring and ordering the part rather than fixing it on the spot.
Ready when you are
Need a garage door sorted in Arlington?
Arlington Garage Door Pros repairs and installs garage doors, springs and openers in Arlington, TX and the surrounding area.